365 X-Torq Bars & Chains
Fitting bars, chains and the drive-link count to order
Cutting system
Your 365 X-Torq runs 3/8" pitch, .058 gauge, and takes 16–28" bars.
- Pitch
- 3/8"
- Gauge
- .058
- Bar mount
- Large
- Bar length
- 16–28"
Bars that fit
Bar options
5 fitting families
Pick your bar length on Bailey’s — then match the chain drive-link count from the reference below.
Chains that fit
Chain options
4 fitting families
C85 (3/8" x .058") X-Cut Chisel Chainsaw Chain
C85S (3/8" x .058" Skiptooth) X-Cut Chisel Chainsaw Chain
Drive-link reference
Order the chain by drive-link count for your bar length (3/8" pitch).
| Bar length | Drive links |
|---|---|
| 16" | 60 |
| 18" | 68 |
| 20" | 72 |
| 24" | 84 |
| 28" | 93 |
Not sure what you have?
Read your setup, then match it
Guide barsBar types — what the “type” means
- Laminate
- Lighter bonded-steel plates with a sprocket nose — the everyday choice for homeowner & mid-size saws. Husqvarna X-Force.
- Solid / RSN
- One-piece steel with a serviceable replaceable sprocket nose, built for pro heat and load. Husqvarna X-Tough & X-Tough Light.
- Narrow Kerf / Pixel
- Thinner bar + chain that removes less wood per pass, so a smaller saw cuts faster on less fuel. Common on .325" and LP saws.
- Hardnose
- Solid bar with no nose sprocket, for abrasive or dirty cutting where a sprocket would wear out.
Saw chainsChain cutter styles
- Full chisel
- Square-cornered cutters — the fastest in clean wood. The pro choice for felling and bucking.
- Semi-chisel
- Rounded cutters that stay sharp longer in dirty, frozen, or dry/abrasive wood.
- Skip-tooth
- Fewer cutters spaced farther apart, for long bars and milling where chip clearance matters.
- Narrow kerf
- Thinner cutters matched to narrow-kerf bars on smaller and battery saws.
SharpeningRound file size by pitch
| Pitch | Round file |
|---|---|
| .325" | 3/16" |
| 3/8" | 7/32" |
| 3/8" LP | 5/32" |
| 1/4" | 5/32" |
Husqvarna bar & chain lines
Know the lineup
X-Cut chains
Purpose-built, sharp out of the box
C85, C83, SP33G and S93G — Husqvarna’s premium current line. Low stretch, holds an edge, engineered for the saw.
X-Force & X-Tough bars
Everyday laminate to pro solid RSN
X-Force laminate for homeowner & mid-size saws; X-Tough and X-Tough Light solid RSN bars for professional heat and load.
Cutter styles
Full chisel · semi-chisel · skip-tooth
Full chisel for speed in clean wood, semi-chisel for dirty/frozen cutting, skip-tooth for long bars and milling.
Why genuine Husqvarna
Engineered with the saw, not just for it
Husqvarna bars and chains are built to the saw’s hardness, balance, vibration and cutting geometry. Genuine parts hold an edge longer, run truer, and protect your drive system — which means less downtime and a lower cost per cut.
Exact fitment
Matched pitch, gauge and mount — no guesswork.
Holds an edge
Hardened cutters cut sharper, longer.
Protects the saw
Correct geometry spares your sprocket & drivetrain.
Lower cost per cut
Less downtime, fewer replacements.